Starting up the device - Basic configuration
Leuze electronic
CML 730-PS
67
Select Digital IOs > IO Pin 2 > IO Function > Trigger In.
A teach input is configured according to the same principle.
Select Digital IOs > IO Logic > Positive PNP.
Select Digital IOs > IO Pin 2 > IO Function > Teach input.
Configuration of pin 5 as PNP height area
The following example shows the configuration of pin 5 as PNP height area.
Select Digital IOs > IO Logic > Positive PNP.
Select Digital IOs > IO pin 5 > Teach height > Execute.
8.5.2 Inversion of the switching behavior (light/dark switching)
Light/dark switching is configured with this configuration.
The following example shows how the switching output is switched from light switching (normal) to dark
switching (inverted).
The structure of the configuration in the receiver control panel menu is as follows:
Trigger input and output are only active if cascading (triggered operation) was activated via the
configuration interface or process interface.
NOTICE
Configuration of the teach input can activate the key lock!
The setting of the teach input becomes effective immediately.
Depending on the applied signal level, this can immediately activate the
Key lock
function (see
Level 0
Level 1
Level 2
Description
Digital IOs
IO Logic
Positive PNP
Negative NPN
IO Pin 5
IO Function Trigger In
Teach In
Area Out
Warn Out
Trigger Out
Validation Out
Inversion
Normal
Inverted
Teach
height
Execute
Exit
Area Logic
AND
OR
Start Beam
(enter value)
End Beam
(enter value)
The pin is automatically configured as an area output.
IO Function > Area Out must also be selected.
For all digital process interfaces, the configuration can also be performed via the IO-Link inter
-
face (see chapter 10) or via the
Sensor Studio
configuration software (see chapter 12).
Level 0
Level 1
Level 2
Description
Digital IOs
IO Logic
Positive PNP
Negative NPN
IO Pin 2
IO Function Trigger In
Teach In
Area Out
Warn Out
Trigger Out
Validation Out