Leuze BCL604i, Руководство по эксплуатации

Страница: 92 / 127

Starting up the device - Configuration
Leuze electronic BCL 604i 92
Input data length:
2 bytes
Output data
Table 10.53: Output data for module 74 Input/output status and control
Output data length:
2 bytes
10.13 Data output
10.13.1Module 80 – Sorting
Description
Module to support the sorting of the output data.
Switching output 3
Comparison state tog
-
gle bit
(Event Counter)
If “SWOUT switches several times” was con
-
figured as comparison mode, this bit is toggled
each time the event counter is exceeded.
The bit is reset to the init. value by resetting
the event counter.
1.5 Bit 0 -> 1: Event counter
exceeded
1 -> 0: Event counter
exceeded again
0 -
Comparison state
switching output 4
(Event Counter)
Indicates whether the event counter has
exceeded the set comparative value.
The bit is reset to the init. value by resetting
the event counter.
1.6 Bit 0: Not exceeded
1: Exceeded
0 -
Switching output 4
Comparison state tog
-
gle bit
(Event Counter)
If “SWOUT switches several times” was con
-
figured as comparison mode, this bit is toggled
each time the event counter is exceeded.
The bit is reset to the init. value by resetting
the event counter.
1.7 Bit 0 -> 1: Event counter
exceeded
1 -> 0: Event counter
exceeded again
0 -
Parameter Description Addr. Data type Value range Init value Unit
Output data Description Addr. Data type Value range Init value Unit
Switching output 1 Sets the state of switching output 1 0.0 Bit 0: Switching output 0
1: Switching output 1
0 -
Switching output 2 Sets the state of switching output 2 0.1 Bit 0: Switching output 0
1: Switching output 1
0 -
Switching output 3 Sets the state of switching output 3 0.2 Bit 0: Switching output 0
1: Switching output 1
0 -
Switching output 4 Sets the state of switching output 4 0.3 Bit 0: Switching output 0
1: Switching output 1
0 -
Reset Event Counter
Switching output 1
Sets the event counter of the activation func
-
tion [AF] for switching output 1 back to zero.
0.4 Bit 0 -> 1: Perform reset
1 -> 0: No function
0 -
Reset Event Counter
Switching output 2
Sets the event counter of the activation func
-
tion [AF] for switching output 2 back to zero.
0.5 Bit 0 -> 1: Perform reset
1 -> 0: No function
0 -
Reset Event Counter
Switching output 3
Sets the event counter of the activation func
-
tion [AF] for switching output 3 back to zero.
0.6 Bit 0 -> 1: Perform reset
1 -> 0: No function
0 -
Reset Event Counter
Switching output 4
Sets the event counter of the activation func
-
tion [AF] for switching output 4 back to zero.
0.7 Bit 0 -> 1: Perform reset
1 -> 0: No function
0 -
Reserved 1 Byte