Online commands
Leuze electronic GmbH + Co. KG
BCL 8
54
Software reset
autoConfig
Command
’H’
Description
Carries out a software reset. The device is restarted and reinitialized, leaving
it in the same state as when the supply voltage is switched on.
Parameter
No
Acknowledgment
’S’ (start signal)
Command
’CA’
Description
Activates or deactivates the ’autoConfig’ function. Certain label reading
parameters are programmed automatically in the setup by the labels which
the BCL 8 reads while the 'autoConfig' function is active.
Parameter
’+’ Activates ’autoConfig’
’/’ Rejects the last code read
’-’ Deactivates ’autoConfig’ and stores the decoded data in the current
parameter set
Acknowledgment
’CSx’
x
Status
’0’ Valid ’CA’ command
’1’ Invalid command
’2’ autoConfig could not be activated
’3’ autoConfig could not be deactivated
’4’ Result could not be deleted
Description
’xx yy zzzzzz’
xx Code type of the read code
’01’ 2/5 Interleaved
’02’ Code 39
’06’ UPC (A, E)
’07’ EAN
’08’ Code 128, EAN 128
’09’ Pharmacode
’10’ EAN/UPC
’11’ Codabar
’12’ Code 93
yy No. of digits of the read code
zzzzzz
Contents of the decoded label. The
appears if the label was not cor
-
rectly read.
