Starting up the device - Basic configuration
Leuze electronic GmbH + Co. KG
CML 730i
73
8.5.2 Inversion of the switching behavior (light/dark switching)
Light/dark switching is configured with this configuration.
The following example shows how the switching output is switched from light switching (normal) to dark
switching (inverted).
The structure of the configuration in the receiver control panel menu is as follows:
Select Digital IOs > IO Pin 2 > Inversion > Inverted.
8.5.3 Defining the filter depth
The filter depth is used to specify that an evaluation and output of the measurement values occurs only
once the beam states are stable over multiple measurement cycles.
Example: with a filter depth of “5”, five measurement cycles must be consistent before an evaluation is
performed. For further information, see also the description of interference suppression (see
The pin is automatically configured as an area output.
IO Function > Area Out must also be selected.
For all digital process interfaces, the configuration can also be performed via the respective field
-
bus interface (see chapter 10 et seq.) or via the
Sensor Studio
configuration software (see
Level 0
Level 1
Level 2
Description
Digital IOs
IO Logic
Positive PNP
Negative NPN
IO Pin 2
IO function
Trigger In
Teach In
Area Out
Warn Out
Trigger Out
Inversion
Normal
Inverted
Teach height
Execute
Exit
Area logic
AND
OR
Start beam
(enter value)
End beam
(enter value)
Level 0
Level 1
Level 2
Description
Digital IOs
IO Logic
Positive PNP
Negative NPN
IO Pin 2
IO function
Trigger In
Teach In
Area Out
Warn Out
Trigger Out
Validation Out
Inversion
Normal
Inverted
Teach
height
Execute
Exit
Area logic
AND
OR
Start beam
(enter value)
End beam
(enter value)
