Leuze electronic DDLS 508, Руководство по эксплуатации

Страница: 24 / 58

Mounting
Leuze electronic DDLS 508 25
1 Level
2 Alignment screw for vertical alignment
Figure 4.7: Vertical alignment of the target spot
The target spot of the alignment laser on the opposing wall exactly marks the position at which the second
device must be mounted.
Mounting the second device

Affix the drilling template at the target spot of the alignment laser. Use the supplied self-adhesive labels.

Drill the holes for mounting the device with the aid of the drilling template or, if C profile rails are present,
align them according to the drilling template.
Mount the device with four M5 screws via the fastening holes in the mounting plate.
The device must be mounted in a vertical position.
• Check the vertical mounting with a separate level.
• Place the level on the edge of the mounting plate.

Switch off the alignment laser of the device that was mounted first.
Activate the AUT (Automatic) operating mode to switch off the alignment laser (see chapter 6.1).

Detach the contour of the optical window from the drilling template along the perforation.
Affix the removed drilling template to the optical window of the device that was mounted first using the
supplied self-adhesive labels.

Connect the second device electrically (see chapter 5 "Electrical connection").
The AUT LED (continuous light) indicates that the start-up phase of the device after “POWER on” has
been concluded. After the start-up phase, the operating mode can be changed.

Switch on the alignment laser of the second device.
Activate the LAS (Alignment laser) operating mode to switch on the alignment laser (see chapter 6.1).

Point the alignment laser of the device that was mounted second at the drilling template on the device
that was mounted first.
To do this, align the second device using the alignment screws.
The level as well as the parallelism of the laser spots to the guide rail does not need to be taken into
account here.
Small changes to the alignment screw cause the air bubble in the level to move slowly. Before
making further settings, wait until the air bubble stops moving.
1
2