Interbus interface
51
AMS 384
i
Leuze electronic
9.5.1
Default settings of the Interbus interface
Table 9.3:
Default settings of the Interbus interface
Notice!
The AMS 384
i
cannot be configured via the Interbus.
The settings labeled with footnote 1) can be changed via the display. Changed parameters
are stored in the AMS 384
i
and are reactivated following power off/on.
Default parameters of the AMS 384
i
xxx (H)
Interbus activation
1)
1)
Parameter can be changed via the control panel/display
ON
Baud rate
500 kbit/s
Ident code
32H
Number of data bits
32
Data breakdown
23-bit measurement value, 1-bit sign, 2-bit reserved, 3-bit pre-failure messages,
2-bit errors, 1-bit statically set to binary
1
Measurement value display
1)
Gray
Unit
1)
Metric
Resolution
1)
1mm
Count direction
1)
Positive
I/O 1
1)
Input LOW = laser on, HIGH = laser off
I/O 2
1)
Velocity monitoring output set to > 0.2m/s (configurable)
Static preset
1)
+ 000.000
Dynamic preset
1)
+ 000.000
Pos. limit value range 1
1)
Lower and upper limit, both 000.000
Pos. limit value range 2
1)
Lower and upper limit, both 000.000
Error handling procedures
1)
Position output: 000.000
Position status suppression: active
Error delay time: 100 ms
Display language
1)
English
Display illumination
1)
Off after 10 min.
Display contrast
1)
Medium
Password protection
1)
Off
Password
1)
0000
