STEP 1
STEP 2
STEP 2
PAGE 2 OF 6
Install Spring Nut [
W
] into the Shank [
B
]
by aligning the Spring nut coil with the
pin holes located in the shank.
[Detail 1].
With the Spring Nut [
W
] aligned with the
pin holes, install the Shank [
B
] into the
vehicles hitch receiver. [Detail 2]
Using one Silent Hitch Pin [
F
], a Spring Washer [
G
] and
Flat Washer [
H
] thread the the Silent Hitch Pin through the
Receiver, the Shank [
B
] and the Spring Nut [
W
] as shown.
Note: Silent Hitch Pin must be inserted in the
Block Side
of
the Spring Nut first in order to thread the Spring Nut fully.
Fully thread the Silent Hitch Pin
until tight or to 30 ft. lbs.
Attach a Large Retainer Clip [
K
] onto the end of the Silent
Hitch Pin to secure. [Detail 3]
Insert Rear Mast [
C1
] in the Shank [
B
]
and align the hole positions. In the
hole position located closest to the
hitch install the Large Tilt-Position Pin
[
Q
] and secure with Large Retainer
Clip [
K
]. In the Adjacent hole next to
the Tilt-Position Pin, insert the Large
Shank Bolt [
R
] and secure with the
Large Locking Shank Nut [
S
]. Fully
thread the Shank Nut
until tight or to
40 ft. lbs.
[Detail 4]
In the same manor as STEP 1 & 2,
insert Spring Nut [
W
] at the open end
of the Forward Mast [
C2
] and insert
the Forward Mast [
C2
] into the Rear
Mast [
C1
]. Secure with Silent Hitch
Pin [
F
], Spring Washer [
G
], and Flat
Washer [
H
] as before (Refer to STEP
1 & 2). [Detail 4]
Hit
ch R
eceiv
er
W
F
K
R
Q
K
K
S
G
G
H
H
W
B
B
B
F
ALWAYS CHECK TO BE SURE SILENT HITCH PIN AND RETAINER
CLIP ARE PROPERLY SECURED BEFORE TRANSIT
BE SURE ALL CONNECT
WARNING:
NOTICE:
W
C1
C2
DETAIL 1
DETAIL 3
DETAIL 4
DETAIL 2
