Intalling Your Wireless Light Switch
1. Before installation, verify that everything is included in your kit and that you have the items, listed above, ready
for use.
• Each kit includes a Single Rocker Self-Powered Light Switch, (1) ILLUMRA 3-wire Relay Receiver, (2) 6-32 x 3/4” phillips flathead self tapping screws, (2) 6 x
3/8” phillips flathead screws, (1) Faceplate w/ screws, (1) Installation Guide.
• If the receiver will be installed in an existing light switch junction box, you will need a junction box cover to cover the receiver and box.
• Wire nuts and electrical tape are required to secure the connection between the light fixture wires and the receiver wires.
• Depending on where and how you install the wireless light switch, double-sided tape or wall screws will be required to secure the light switch to the wall.
2. Turn off the power to the switch
through the breaker.
WARNING
: To avoid risk of fire, shock, or death, TURN OFF
POWER at circuit breaker or fuse and verify that it is OFF
before installation begins. Make sure that it remains OFF
until installation is complete. Please be aware that with some
versions of the product, it is possible to have multiple branch
circuits feeding the Relay Receiver.
3. Remove old light switch from
junction box and dispose
Our Wireless Switch Kit is designed to last up to 20 years
and can be used in multiple homes. Therefore, step three
may be replaced by saving your old light switch to put
back if you plan on moving your wireless light switch to
your new home.
4. Connect receiver wires to the existing wires in the junction box.
• The hot wire will be black and the neutral wire will be white.
• If no neutral wire is available in the switch junction box, you will need to wire the receiver into the junciton box of the light fixture.
• Use wire nuts and electrical tape to connect the wires.
• Wiring Diagram is on the back of this installation guide.
SAFETY NOTE - If your fixture is a ceiling-hugger fixture, use only compact flourescent bulbs to avoid overheating. Also, if you are unsure about the wiring,
contact a local electrician.
5. Cover junction box with face plate.
Covering the junction box after installing the receiver will reduce the risk of injury, fire, and electrical failure. DO NOT cover
the junction box with drywall and paint as you may need to access the receiver in the future.
Single Rocker Switch and 3-Wire Receiver
