Lepu Medical AIView 12V, Руководство оператора, Страница: 54 / 292

3-19
3.11.9 Setting Password Protection
You can set whether changing alarm-related settings is password
protected or not. To do so, follow the steps below:
1. Press [Main Menu]
→
[Maintenance]
→
input password
→
press [Enter].
2. Select the [Alarm] tab.
3. Switch on or off [Alarm Setup Password] as needed.

If [Alarm Setup Password] is switched on, changing the
alarm switch, alarm high and low limits, alarm priorities and
alarm volume settings are password protected. The
password is the user maintenance password (i.e., admin
password) of the monitor.

If [Alarm Setup Password] is switched off, changing the
alarm settings is not password protected.
3.12 Turning off the Monitor
To turn off the monitor, follow the steps below:
1. Confirm that patient monitoring has been completed.
2. Disconnect the cables and sensors from the patient.
3. Save or clear the patient data as required.
4. Press and hold the power switch for 3 seconds to turn off the
monitor.
Caution
Although not recommended, you can press and hold the power switch for
10 seconds to forcibly shut down the monitor when it cannot be shut down
normally. However, this operation may cause loss or corruption of patient
data, please proceed with caution.

Note
Turning off the monitor does not disconnect the monitor from the AC mains.
To completely disconnect the power supply, unplug the power cord.

Note
If the monitor is equipped with a rechargeable battery, charge the battery
after using the monitor every time to ensure that there is sufficient electric
power.