Lenze PositionServo 940, Руководство пользователя

Страница: 20 / 68

S94P01B
18
STOP!
Use only +5 VDC encoders. Do not connect any other type of encoder
to the PositionServo 940 reference voltage terminals. When using a
front-end controller, it is critical that the +5 VDC supply on the front-
end controller NOT be connected to the PositionServo 940’s +5 VDC
supply, as this will result in damage to the PositionServo 940.
Note
• The PositionServo 940 encoder inputs are designed to accept
differentially driven hall signals. Single-ended or open-collector
type hall signals are also acceptable by connecting “HA+”, “HB+”,
“HC+” and leaving “HA-,HB-,HC-” inputs unconnected. You do not
need to supply pull-up resistors for open-collector hall sensors. The
necessary pull-up circuits are already provided.
• Encoder connections (A, B, and Z) must be full differential.
PositionServo doesn’t support single-ended or open-collector type
outputs from the encoder.
• An encoder resolution of 2000 PPR (pre-quadrature) or higher is
recommended.
Using P4 as second encoder input for dual-loop operation.
P4 can be used as a second loop encoder input in situations where the motor is
equipped with a resolver as the primary feedback. If such a motor is used, the drive
must have a resolver feedback option module installed. A second encoder can then be
connected to the A and B lines of the P4 connector for dual loop operation. See “Dual
loop feedback operation” for details (Section 8.4).
P4 PIN ASSIGNMENTS (ENCODER)
Pin Name Function
1 EA+ Encoder Channel A+ Input (1)
2 EA- Encoder Channel A- Input
(1)
3 EB+ Encoder Channel B+ Input
(1)
4 EB- Encoder Channel B- Input (1)
5 EZ+ Encoder Channel Z+ Input
(1)
6 EZ- Encoder Channel Z- Input
(1)
7 GND Drive Logic Common/Encoder Ground
8 SHLD Shield
9 PWR Encoder supply (+5VDC)
10 HA- Hall Sensor A- Input
11 HA+ Hall Sensor A+ Input
12 HB+ Hall Sensor B+ Input
13 HC+ Hall Sensor C+ Input
14 HB- Hall Sensor B- Input
15 HC- Hall Sensor C- Input
(1)
See Note 1, Section 5.1.7 - Connector and Wiring Notes