Electrical installation
Mounting steps
4
33
EDKRBD180R DE/EN/FR 2.0
How to connect the brake resistor:
1. Undo the two screws
at the terminal box and remove cover
.
2. Connect brake resistor cable:
–
Use shielded cables (2 cores + PE; the PE connection must comply with EN
50178).
–
Pass the cable through M25 cable gland
.
–
The shield must be tightly connected to the cable gland.
–
Connect the cores to the terminals RB1, RB2 and PE of the brake resistor
observing the tightening torque.
–
Connect cores and shield to the basic device
observing the
documentation on the basic device.
–
Tighten the cable gland
.
3. Connect temperature sensor cables:
–
Pass the cable through M12 cable gland
(2 cores).
–
Connect the cores to terminals T1 and T2 of the brake resistor observing
the tightening torque.
–
Switching capacity: 250 V AC/0.5 A
–
Integrate the thermal contact into the controller enable chain
of the
basic device.
–
Tighten the cable gland
.
4. Place cover
on the terminal box and fasten with 2 screws / 2 washers
.
All manuals and user guides at all-guides.com
