Lenovo x3650 M5, Инструкция по установке и обслуживанию

Страница: 219 / 1340

2. Make sure the wire cables are routed in the proper locations without blocking the retention
brackets installation.
Step 9. Reinstall the top cover (see “Replacing the top cover” on page 151).
Step 10. Slide the server into the rack.
Step 11. Reconnect the power cords and all external cables, and turn on the server and peripheral devices.
Removing the rear two hard-disk-drive kit
Use this information to remove the rear two hard-disk-drive kit.
See http://www.lenovo.com/ serverproven/ for a list of hard disk drives that you can use with the server.
To remove the rear two hard-disk-drive kit, complete the following steps:
Step 1. Read the safety information that begins on page “Safety” on page v and “Installation guidelines” on
page 297.
Step 2. Turn off the server and peripheral devices, and disconnect the power cord and all external cables.
Step 3. Remove the top cover (see “Removing the top cover” on page 149).
Step 4. Grasp the kit at the front and the rear edge and lift it up to remove from the server. Place the kit
on a flat, static-protective surface.
• 2.5-inch rear two hard-disk-drive kit removal
0000
0000
0000
0000
0
0
0
0
0
0
0
0
0
000
000
000
000
000
000
000
000
0
0
0
0
0
0
0
0
2.5-inch rear two
hard-disk-drive kit 1
Figure 143. 2.5-inch rear two hard-disk-drive kit removal
• 3.5-inch rear two hard-disk-drive kit removal
Chapter 5
.
Installing, removing, and replacing components
207