Lenovo tihnkserver rd330, Руководство по техническому обслуживанию аппаратной части

Страница: 32 / 198

The following illustration shows the controls, connectors, and LEDs on the front panel of the server.
ID
Figure 8. Front panel
1
Power switch with power status LED
5
System error LED
2
ID button with ID LED
6
Front USB connector 1
3
Network Interface Controller (NIC) 1 status LED
7
Front USB connector 2
4
NIC 2 status LED
8
Front VGA DB-15 connector
Note: The front VGA DB-15 connector is only available in server models with 2.5-inch hard disk drives.
1 Power switch with power status LED
You can press the power switch to turn on the server when you finish setting up the server. You also can
hold the power switch for several seconds to turn off the server if you cannot turn it off from the operating
system. See Chapter 4 “Turning on and turning off the server” on page 45. The power status LED helps you
to determine the current power status.
Power status LED
Color
Description
On Green The server is on.
Off None The server is off.
Blinking Green The server is in ACPI S1 mode, which also is known
as Power On Suspend (POS) mode. In this mode, the
microprocessor is not working while other hardware
devices are still working.
2
ID button with ID LED
When you press the ID button, the ID LEDs on both the front and rear of the server are lit to help you locate
the server among other servers. You also can turn on the ID LEDs using a remote management program
for server presence detection.
ID LED
Color
Description
On Blue The server is identified.
Off None The ID LED is not in use or the server is not identified.
18
ThinkServer RD330 Hardware Maintenance Manual