Lenovo ThinkSystem SR950, Руководство по установке, Страница: 342 / 390

The BMC/IMM/XCC account password (1 of 12 accounts).
Example commands are as follows:
onecli config set SYSTEM_PROD_DATA.SysInfoProdName <m/t_model>
--bmc
-username xcc_user_id
--bmc
-password xcc_password
onecli config set SYSTEM_PROD_DATA.SysInfoSerialNum <s/n>
--bmc
-username xcc_user_id
--bmc
-password xcc_password
– Online KCS access (unauthenticated and user restricted):
You do not need to specify a value for
access_method
when you use this access method.
Example commands are as follows:
onecli config set SYSTEM_PROD_DATA.SysInfoProdName <m/t_model>
onecli config set SYSTEM_PROD_DATA.SysInfoSerialNum <s/n>
Note:
The KCS access method uses the IPMI/KCS interface, which requires that the IPMI
driver be installed.
– Remote LAN access, type the command:
[
−−bmc
xcc_user_id:xcc_password@xcc_external_ip]
Where:
xcc_external_ip
The BMC/IMM/XCC IP address. There is no default value. This parameter is required.
xcc_user_id
The BMC/IMM/XCC account (1 of 12 accounts). The default value is USERID.
xcc_password
The BMC/IMM/XCC account password (1 of 12 accounts).
Note:
BMC, IMM, or XCC internal LAN/USB IP address, account name, and password are all
valid for this command.
Example commands are as follows:
onecli config set SYSTEM_PROD_DATA.SysInfoProdName <m/t_model>
−−bmc
xcc_user_id:xcc_password@xcc_external_ip
onecli config set SYSTEM_PROD_DATA.SysInfoSerialNum <s/n>
−−bmc
xcc_user_id:xcc_password@xcc_external_ip
4. Reset the Lenovo XClarity Controller to the factory defaults. See “Resetting the BMC to Factory
Default” section in the XCC documentation compatible with your server at
https://
sysmgt.lenovofiles.com/help/topic/lxcc_frontend/lxcc_overview.html .
Enable TPM/TCM
The server supports Trusted Platform Module (TPM), Version 1.2 or Version 2.0
Note:
For customers in Chinese Mainland, TPM is not supported. However, customers in Chinese Mainland
can install a Trusted Cryptographic Module (TCM) adapter (sometimes called a daughter card).
When a system board is replaced, you must make sure that the TPM/TCM policy is set correctly.
CAUTION:
Take special care when setting the TPM/TCM policy. If it is not set correctly, the system board can
become unusable.
Set the TPM policy
By default, a replacement system board is shipped with the TPM policy set to
undefined
. You must modify
this setting to match the setting that was in place for the system board that is being replaced.
338
ThinkSystem SR950 Setup Guide