Lenovo thinksystem SR630, Руководство по обслуживанию

Страница: 87 / 182

Before installing the backplane, touch the static-protective package that contains the new backplane to any
unpainted surface on the outside of the server. Then, take the new backplane out of the package and place it
on a static-protective surface.
To install the backplane, complete the following steps:
Watch the procedure . A video of the installation process is available:
• Youtube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-C_GGjNudxYy8-c69INMcmE
• Youku:
http://list.youku.com/albumlist/show/id_50462008
Figure 68. Installation of backplane for eight 2.5-inch hot-swap drives
Step 1. Align the two pins 1 on the backplane with the corresponding holes 2 in the chassis.
Step 2. Lower the backplane into the chassis. Ensure that the pins pass through the holes and the
backplane is fully seated in place.
After installing the backplane:
1. Connect the cables to the backplane. See “Server models with eight 2.5-inch drives” on page 31.
2. Reinstall all the drives and drive fillers into the drive bays. See “Install a hot-swap drive” on page 66.
3. Complete the parts replacement. See “Complete the parts replacement” on page 141.
Remove the backplane for ten 2.5-inch hot-swap drives
Use this information to remove the backplane for ten 2.5-inch hot-swap drives.
Chapter 3
.
Hardware replacement procedures
79