Lenovo ThinkSystem SR530, Руководство по обслуживанию

Страница: 85 / 184

If you are instructed to return the old simple-swap drive backplate assembly, follow all packaging
instructions and use any packaging materials that are provided.
Install the simple-swap drive backplate assembly
Use this information to install the simple-swap drive backplate assembly.
“
Read
the
installation
Guidelines” on
page 45
“
Power off
the server
for this task”
on page 14
“
ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 48
Before installing the simple-swap drive backplate assembly, touch the static-protective package that
contains the new backplate assembly to any unpainted surface on the outside of the server. Then, take the
new backplate assembly out of the package and place it on a static-protective surface.
To install the simple-swap drive backplate assembly, complete the following steps:
Figure 49. Simple-swap drive backplate assembly installation
Step 1. Put the backplate assembly under the front I/O assembly cables, align it with the chassis, and lower
it into the chassis. Put the backplate assembly into place with it leaning backward slightly so that
the three pins
1
on the chassis pass through the three holes
2
in the assembly.
Step 2. Close the release latches to secure the backplate assembly in place.
Chapter 3
.
Hardware replacement procedures
77