Lenovo ThinkSystem SR530, Руководство по обслуживанию

Страница: 81 / 184

Step 2. Pivot the backplane backward slightly to release it from the three pins
1
on the chassis.
Step 3. Carefully remove the backplane out of the chassis from under the front I/O assembly cables.
If you are instructed to return the old backplane, follow all packaging instructions and use any packaging
materials that are provided.
Install the backplane for four 3.5-inch hot-swap drives
Use this information to install the backplane for four 3.5-inch hot-swap drives.
“
Read
the
installation
Guidelines” on
page 45
“
Power off
the server
for this task”
on page 14
“
ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 48
Before installing the backplane, touch the static-protective package that contains the new backplane to any
unpainted surface on the outside of the server. Then, take the new backplane out of the package and place it
on a static-protective surface.
To install the backplane, complete the following steps:
Watch the procedure
. A video of the installation process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-AQrHuDWK6L3KtHWc6maY_O
• Youku:
http://list.youku.com/albumlist/show/id_50437162
Figure 45. Backplane installation
Chapter 3
.
Hardware replacement procedures
73