Lenovo ThinkStation P910, Руководство по техническому обслуживанию аппаратной части

Страница: 159 / 244

6. Install the bracket with the new storage drive into the hard-disk-drive bay. See step 6 on page 151.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 213.
Installing or replacing a 2.5-inch storage drive with a converter in a hard-disk-drive bay
Attention:
Do not open your computer or attempt any repair before reading and understanding the Chapter
1 “Read this first: Important safety information” on page 1.
To install or replace a 2.5-inch storage drive with a 2.5-inch to 3.5-inch converter in a hard-disk-drive
bay, do the following:
1. Prepare your computer. See “Preparing your computer and removing the computer cover” on page 101.
2. Locate the hard-disk-drive bay in which you want to install or replace a storage drive. See “Internal
drives” on page 37.
3. Remove the storage drive bracket from the hard-disk-drive bay. See step 3 on page 148.
4. Depending on whether you are installing or replacing a storage drive, do one of the following:
• If you are installing a storage drive, pivot tab 1 on the metal adapter upward. Then, push the adapter
as shown until the four tabs on the adapter are slide into the four notches
2
. Pivot the adapter as
shown to remove it from the converter.
1
2
Figure 97. Removing the adapter from the converter
• If you are replacing a storage drive, do the following:
a. Remove the converter from the bracket. See step 4 on page 148.
Chapter 9
.
Installing or replacing hardware
153