Lenovo ThinkStation P910, Руководство по техническому обслуживанию аппаратной части

Страница: 153 / 244

9. Route the cables through the two holes in the rear of the flex module. Position the flex module cover
on the flex module. Ensure that the rail guides on the bottom of the cover engage the rails on the flex
module. Then, push the cover to the front of the flex module until it snaps into position.
Figure 90. Reinstalling the flex module cover
10. Install the flex module into the optical-drive bay. See “Device in an optical-drive bay” on page 107.
11. Connect the cables to the front Thunderbolt PCI Express x4 card and the system board.
• Connect the GPIO cable to the Thunderbolt connector on the system board. See “Parts on the
system board” on page 35.
• Connect the internal DP-to-DP cable to the DisplayPort connector on the front Thunderbolt PCI
Express x4 card.
• Connect the Mini-SAS cable to the SAS connector on the front Thunderbolt PCI Express x4 card.
12. Reconnect any removed cables to the flex module.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 213.
Internal storage drive
Depending on your computer model, your computer might come with one or more of the following internal
storage drives:
• 3.5-inch hard disk drive
• 3.5-inch hybrid drive
• 2.5-inch hard disk drive
• 2.5-inch solid-state drive
• M.2 solid-state drive
• PCI Express solid-state drive
To install or replace an internal storage drive, refer to one of the following topics:
• “3.5-inch storage drive” on page 148
• “2.5-inch storage drive” on page 151
• “M.2 solid-state drive” on page 156
Chapter 9
.
Installing or replacing hardware
147