Lenovo ThinkAgile VX 4-Socket 4U Certified Node, Руководство пользователя

Страница: 231 / 296

Figure 130. Riser for slot 10 to 15 (riser 2) installation
Step 1. Align the riser with the I/O tray and insert it; then, press the riser into the I/O tray until the connector
is fully seated.
Step 2. Tighten the two captive screws (items 4 in preceding figure) that secure the riser to the I/O tray
board.
If you have no other operations to perform on the I/O tray after installing the riser for slot 10 to 15, install the I/
O tray in the chassis and connect all cables. See “Install the I/O tray” on page 154.
Install the riser bracket for slot 14 to 15 (riser 2)
The riser bracket for slot 14 to 15 is attached to the slot 10 to 15 I/O tray riser that is accessed from the rear
of the server. After removing the I/O tray and the riser for slot 10 to 15 (riser 2), slide the bracket onto the riser
until the retaining clips engage.
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Chapter 9
.
Hardware replacement procedures
221