Lenovo ThinkAgile MX3321-F, Руководство пользователя

Страница: 51 / 126

Figure 19. Air baffle installation
Step 1. Align the tabs on both sides of the air baffle with the corresponding slots on both sides of the
chassis.
Step 2. Lower the air baffle into the chassis and press the air baffle down until it is securely seated.
After installing the air baffle:
1. If there is a RAID super capacitor module installed on the bottom of the air baffle, connect it to the RAID
adapter with the extension cable that comes with the RAID super capacitor module.
2. Complete the parts replacement. See “Complete the parts replacement” on page 34.
Hot-swap drive replacement
Use this information to remove and install a hot-swap drive. You can remove or install a hot-swap drive
without turning off the server, which helps you avoid significant interruption to the operation of the system.
Notes:
• The term “hot-swap drive” refers to all the supported types of hot-swap hard disk drives, hot-swap solid-
state drives, and hot-swap NVMe drives.
• Use any documentation that comes with the drive and follow those instructions in addition to the
instructions in this topic. Ensure that you have all the cables and other equipment that are specified in the
documentation that comes with the drive.
• The electromagnetic interference (EMI) integrity and cooling of the server are protected by having all drive
bays covered or occupied. The vacant bays are either covered by an EMI-protective panel or occupied by
drive fillers. When installing a drive, save the removed drive filler in case that you later remove the drive
and need the drive filler to cover the place.
• To avoid damage to the drive connectors, ensure that the top cover is in place and fully closed whenever
you install or remove a drive.
Chapter 5
.
Hardware replacement procedures
47