Lenovo ThinkAgile MX Certified Node 2U, Руководство пользователя

Страница: 64 / 104

Before installing the LOM adapter:
1. If the server comes with a LOM adapter slot bracket, remove it with a tool first. Store the bracket in case
that you later remove the LOM adapter and need the bracket to cover the place.
CAUTION:
Use a tool to remove the LOM adapter slot bracket to avoid injury.
2. Touch the static-protective package that contains the new LOM adapter to any unpainted surface on the
outside of the server. Then, take the new LOM adapter out of the package and place it on a static-
protective surface.
To install the LOM adapter, complete the following steps:
Figure 28. LOM adapter installation
Step 1. Place the LOM adapter into the connector at an angle.
Step 2. Rotate the LOM adapter down.
Step 3. Push the LOM adapter as shown to insert it into the connector on the system board.
Step 4. Tighten the thumbscrew to secure the LOM adapter.
Step 5. Align the mounting stud on the chassis with the hole in the LOM-adapter air baffle. Then, pinch the
tab 1 and lower the LOM-adapter air baffle onto the LOM adapter.
After installing the LOM adapter, complete the parts replacement. See “Complete the parts replacement” on
page 32.
M.2 backplane and M.2 drive replacement
Use this information to remove and install the M.2 backplane and M.2 drive (an assembled M.2 backplane
and M.2 drive also known as M.2 module).
Remove the M.2 backplane and M.2 drive
Use this information to remove the M.2 backplane and M.2 drive.
Chapter 4 “ Read
the
installation
Guidelines” on
page 27
“ Power off
the server
for this task”
on page
“ ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 29
60
User Guide forThinkAgile MX Certified Node 2U