Lenovo System x3750 M4, Инструкция по установке и обслуживанию

Страница: 329 / 982

Appendix A. Boot code display error codes
Use this information to resolve boot code error messages.
The boot code display area of the light path diagnostics panel provides an error code that indicates the point
at which the system stopped during the boot block and POST. A boot code is either a byte or a word value
that is produced by UEFI. This display will provide error codes in the event of a microprocessor error or a
power fault. In addition to the IMM log, the codes can provide suggested components to be replaced.
The following is an illustration show the boot code display area on the light path diagnostics panel:
Light Path Diagnostics
The following table lists the error codes that might display in the boot code display area that is associated
with the integrated voltage regulator power faults or microprocessor failure events. Follow the action plan
listed for the corresponding IMM events listed in this table to solve the problem. See the Appendix D
“Integrated management module II (IMM2) error messages” on page 509 for the corresponding IMM event ID
and action plan to follow and correct the problem.
Table 45. System power faults
Boot
code
Message
Potential defective
component Corresponding
IMM Event ID Corresponding IMM
log message
01 5V_PGOOD System Board 80070603-0701ffff Sensor System VRD
has transitioned to
non-recoverable.
02 0_8VAUX_PGOOD 10G-T Card 80070603-0B01ffff Sensor 10Gb-T VRD
has transitioned to
non-recoverable.
03 ENET_1_0VAUX_PGOOD System Board 80070603-0701ffff Sensor 10Gb-T VRD
has transitioned to
non-recoverable.
04 1_1V_PGOOD System Board 80070603-0701ffff Sensor MainBrd VRD
has transitioned to
non-recoverable.
© Copyright Lenovo 2016, and 2012, 2016 315