Lenovo System x3650 M4 HD, Инструкция по установке и обслуживанию

Страница: 272 / 1168

Step 9. Turn on the circuit breaker for the dc power source to which the new power supply is connected.
Step 10. Make sure that the green power LEDs on the power supply are lit, indicating that the power supply
is operating correctly.
Step 11. If you are replacing a power supply with one of a different wattage in the server, apply the new
power information label provided over the existing power information label on the server. Power
supplies in the server must be with the same power rating or wattage to ensure that the server
will operate correctly.
Figure 180. Power information label
Step 12. If you are adding a power supply to the server, attach the redundant power information label that
comes with this power supply on the server cover near the power supplies.
Figure 181. Redundant power information label
Removing the hot-swap drive backplane
Use this information to remove the hot-swap drive backplane.
Attention:
1. Before removing any components or disconnecting any cables, keep note of their respective locations
and how they are connected to the system board.
To remove the hot-swap hard disk drive backplane, complete the following steps:
Step 1. Read the safety information that begins on “Safety” on page v and “Installation guidelines”
on page 34.
Step 2. Turn off the server and peripheral devices and disconnect the power cords and all external cables,
if necessary.
Step 3. Remove the cover (see “Removing the cover” on page 195).
260
Lenovo System x3650 M4 HD Installation and Service Guide