Lenovo System x3650 M4 HD, Инструкция по установке и обслуживанию

Страница: 237 / 1168

Step 2. Turn off the server and peripheral devices, and disconnect the power cord and all external cables.
Step 3. Remove the cover (see “Removing the cover” on page 195).
Step 4. Grasp the kit at the front tab and rear edge and lift it to remove it from the server. Place the kit
on a flat, static-protective surface.
0
0
0
0
0
0
0
0000
0000
00
00
000000
000000
000000
0000
0000
0000000
0000000
0000000
0000000
Rear two hard-disk-drive kit
Figure 147. Rear two hard-disk-drive kit removal
Replacing the rear two hard-disk-drive kit
Use this information to replace the rear two hard-disk-drive kit on the system board.
To install the rear two hard-disk-drive kit, complete the following steps:
Step 1. Read the safety information that begins on “Safety” on page v and “Installation guidelines”
on page 34.
Step 2. Turn off the server and peripheral devices and disconnect all power cords.
Step 3. Remove the cover (see “Removing the cover” on page 195).
Step 4. Reinstall any adapters and reconnect any internal cables you might have removed in other
procedures (see “Replacing an adapter” on page 228 and “Internal cable routing and connectors”
on page 179).
Step 5. Align the rear two hard-disk-drive kit with the connector on the system board:
Chapter 6
.
Removing and replacing components
225