64
G8272 Installation Guide
Replacing the Fan Module
To replace a hot-swap fan module, complete the following steps:
1.
Select an empty fan module bay on the rear of the switch. If the target bay is
covered by a blank fan filler plate, loosen the retainer screw and slide the filler plate
out of the slot.
2.
Remove the new fan module from the antistatic shielded bag.
3.
Check the air flow direction (air in or air out) that is printed on the fan module to
ensure it matches with the other fan modules. Slide the fan module into the card
guides in the open slot and gently push it all the way into the slot, so that it firmly
engages with the connector.
4.
Tighten the retaining screw on the fan module. Torque the screw to approximately
0.25 Nm +/- 0.1 Nm (2 inch-pounds).
5.
Make sure that the fan module’s LED is lit.
Содержание RackSwitch G8272
