Lenovo RackSwitch G8272, Руководство по установке

Страница: 35 / 118

© Copyright Lenovo 2019 Chapter 3: Installing G8272 Hardware and Options
35
For convenience, once the G8272 is installed and initialized, you can use the
following command in the switch firmware interface to display the product serial
number and other required information:
For more information, see “Configuring Vital Product Data” on page 70 .
Required Tools
You need the following tools or equipment to install the G8272:
 Standard flat-blade screwdriver
 #2 Phillips screwdriver
 Electrostatic discharge wrist strap
Package Contents
The basic G8272 package contains the following items:
 One RackSwitch G8272 unit with front-to-rear or rear-to-front airflow
 One two-post mounting kit for standard 19” equipment racks:

Two mounting brackets

Screws to attach brackets to the switch unit

Screws to attach the switch unit to the equipment rack
 One console cable kit that includes:

One Mini-USB to RJ45 console cable
 Two AC power cords
 One Important Notices document
 One Warranty Information document
For a list of compatible switch components and options (such as rack-mounting kits,
modules, cords, and cables), see the
Lenovo Networking Catalog .
Environmental Requirements
This section describes the basic environmental requirements for the G8272. Make
sure the location where you install the switch meets the following requirements:
 Install the switch unit in a dry, clean, well-ventilated area.
 Provide adequate space in the front and back of the switch unit, to ensure proper
air flow.
 Make sure that an adequate grounded power supply is within reach of the
switch unit.
 Make sure that twisted-pair cable is routed away from power lines, fluorescent
lighting fixtures and other sources of electrical interference.
G8272> show sys-info