Lenovo RackSwitch G8264, Справочник по командам

Страница: 612 / 794

612
G8264 Command Reference for ENOS 8.4
VRRP Tracking Configuration
These commands are used for setting weights for the various criteria used to
modify priority levels during the master router election process. Each time one of
the tracking criteria is met (see “VRRP Virtual Router Priority Tracking
Commands” on page 606 ), the priority level for the virtual router is increased by a
defined amount.
Note: These priority tracking options only define increment values. These options
do not affect the VRRP master router election process until options under the
VRRP Virtual Router Priority Tracking Commands (see page 606 ) are enabled.
Table 337.
VRRP Tracking Configuration Options
Command Syntax and Usage
tracking ­ priority ­ increment interfaces
<0 ‐ 254>
Defines the priority increment value for active IP interfaces detected on this
switch.
The default value is
2
.
Command mode: Router VRRP
tracking ­ priority ­ increment next ­ hops
<0 ‐ 254>
Defines the priority increment value for each next ‐ hop that is active or
subtracted.
The default value is
2
.
Command mode: Router VRRP
tracking ­ priority ­ increment ports
<0 ‐ 254>
Defines the priority increment value for active ports on the virtual router’s
VLAN.
The default value is
2
.
Command mode: Router VRRP
tracking ­ priority ­ increment virtual ­ routers
<0 ‐ 254>
Defines the priority increment value (0 through 254) for virtual routers in
master mode detected on this switch.
The default value is
2
.
Command mode: Router VRRP
show ip vrrp tracking ­ priority ­ increment
Displays the current configuration of priority tracking increment values.
Command mode: All