Lenovo HR650X V2, Руководство пользователя, Страница: 85 / 192

1. Connect one end of the power cord to the power connector on the power supply unit.
2. Connect the other end of the power cord to a properly grounded electrical outlet.
Step 5. Route the cables and ensure that they are not blocking access to other chassis components.
After you finish
1. If you have adjusted the CMA to gain access to the power supply bay, properly readjust the CMA back
in place.
2. If the server is turned off, turn on the server. Ensure that both the power input LED and the power output
LED on the power supply are lit, indicating that the power supply is operating properly.
OCP 3.0 Ethernet adapter replacement
Use this information to remove and install the OCP 3.0 Ethernet adapter.
Remove the OCP 3.0 Ethernet adapter
Use this information to remove the OCP 3.0 Ethernet adapter.
About this task
CAUTION:
Power off the server and disconnect all power cords from their power sources before performing this
procedure.
Attention:
• Read “Installation Guidelines” on page 25 to ensure that you work safely.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Procedure
Chapter 4
.
Hardware replacement procedures
77