Lenovo HR630X V2, Руководство пользователя

Страница: 57 / 134

Step 5. If the rear backplane is reused, remove the rear backplane. See “Remove the 2.5-inch rear drive
backplane” on page 44.
After you finish
If you are instructed to return the old hot-swap rear drive cage, follow all packaging instructions and use any
packaging materials that are provided.
Install the hot-swap rear drive assembly
Use this information to install the hot-swap rear drive assembly.
About this task
The following illustrates how to install the 2.5-inch rear drive assembly.
Attention:
• Read “Installation Guidelines” on page 27 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Procedure
Step 1. Touch the static-protective package that contains the hot-swap rear drive cage to any unpainted
surface on the outside of the server. Then, take the hot-swap rear drive cage out of the package
and place it on a static-protective surface.
Step 2. Gently press and hold the tab on the hot-swap rear drive cage as shown and remove the air baffle
from the hot-swap rear drive cage.
Figure 24. Air baffle removal
Chapter 4
.
Hardware replacement procedures
49