Lenovo 7X69, Руководство по установке

Страница: 86 / 172

Example:
Intel Xeon 52 15L
and
Xeon Platinum 82 80M
To verify if the presently installed processors support DCPMMs, examine the four digits in the processor
description. Only the processor with description meeting
both
of the following requirements support
DCPMMs.
• Supported memory capacity range varies with the following types of DCPMMs.
–
Large memory tier (L):
The processors with
L
after the four digits (for example:
Intel Xeon
52
15L
)
–
Medium memory tier (M):
The processors with
M
after the four digits (for example:
Xeon Platinum
82 80M
)
–
Other:
Other processors that support DCPMMs (for example:
Intel Xeon Gold 5222
)
In addition, you can take advantage of a memory configurator, which is available at the following site:
http://1config.lenovo.com/#/memory_configuration
DC Persistent Memory Module (DCPMM) setup
Follow the instructions in this section to complete required setup before installing DCPMMs for the first time,
determine the most suitable configuration, and install memory modules accordingly.
Complete the following steps to finish system setup to support DCPMMs, and install the memory modules
according to the designated combination.
1. Update the system firmware to the latest version that supports DCPMMs (see “Update the firmware” on
page 134 ).
2. Make sure to meet all the following requirements before installing DCPMMs.
• All the DCPMMs that are installed must be of the same part number.
• All the DRAM DIMMs that are installed must be of the same type, rank, and capacity with minimum
capacity of 16 GB. It is recommended to use Lenovo DRAM DIMMs of the same part number.
• 64 GB 3DS LRDIMMs are not supported to be mixed with DCPMMs.
3. Refer to “DCPMM and DRAM DIMM installation order” in
Memory Population Reference
to determine
the most suitable combination and the following:
• Number and capacity of the DCPMMs and DRAM DIMMs to install.
• Check if the presently installed processors support the combination. If not, replace the processors
with ones that support the combination.
4. Based on the determined DCPMM combination, acquire the DCPMMs, DRAM DIMMs and processors if
necessary.
5. Replace the processors if necessary (see “Processor and heat sink replacement” in
Maintenance
Manual
).
6. Remove all the memory modules that are installed (see “Remove a memory module” in
Maintenance
Manual
).
7. Follow the slot combination in “DCPMM and DRAM DIMM installation order” in
Memory Population
Reference
to install all the DCPMMs and DRAM DIMMs (see “Install a memory module” on page 104 ).
8. Disable security on all the installed DCPMMs (see “Configure Persistent Memory Module (PMem)” on
page 139 ).
9. Make sure the DCPMM firmware is the latest version. If not, update it to the latest version (see https://
sysmgt.lenovofiles.com/help/topic/com.lenovo.lxca.doc/update_fw.html ).
10. Configure DCPMMs so that the capacity is available for use (see “Configure Persistent Memory Module
(PMem)” on page 139 ).
78
ThinkSystem SR860 Setup Guide