Lenovo 6241, Инструкция по установке и обслуживанию

Страница: 141 / 1990

Select this choice to view the startup sequence or select an option to try and boot from immediately.
Changes in the startup options take effect when you start the server.
• Boot Manager
Select this choice to view, add, delete, or change the device boot order, boot from a file, boot from a
device, or boot the UEFI shell. This choice is on the full Setup utility menu only.
• System Event Logs
Select this choice to enter the System Event Manager, where you can view the UEFI/POST event log and
the system-event log. You can use the arrow keys to move between pages in the error log. This choice is
on the full Setup utility menu only.
The POST event log contains the most recent error codes and messages that were generated during
POST.
The system-event log contains POST and system management interrupt (SMI) events and all events that
are generated by the baseboard management controller that is embedded in the integrated management
module (IMM).
Important: If the system-error LED on the front of the server is lit but there are no other error indications,
clear the system-event log. Also, after you complete a repair or correct an error, clear the system-event
log to turn off the system-error LED on the front of the server.
– POST Event Viewer
Select this choice to enter the POST event viewer to view the error messages in the POST event log.
– System Event Log
Select this choice to view the system-event log.
– Clear System Event Log
Select this choice to clear the system-event log.
• User Security
Select this choice to set, change, or clear passwords. The full Setup utility menu, enables all of the options
in the User Security option. See “Passwords” on page 128 for more information.
This choice is on the full and limited Setup utility menu.
– Set Power-on Password
Select this choice to set or change a power-on password. See “Power-on password” on page 128 for
more information.
– Clear Power-on Password
Select this choice to clear the power-on password.
– Set Administrator Password
Select this choice to set or change an administrator password. An administrator password is intended
to be used by a system administrator; it limits access to the full Setup utility menu. If an administrator
password is set, the full Setup utility menu is available only if you type the administrator password at
the password prompt. For more information, see “Administrator password” on page 129.
– Clear Admin Password
Select this choice to clear the Administrator Password.
• Save Settings
Select this choice to save the changes that you have made in the settings. This choice is on the full Setup
utility menu only.
• Restore Settings
Select this choice to cancel the changes that you have made in the settings and restore the previous
settings. This choice is on the full Setup utility menu only.
Chapter 3
.
Configuration information and instructions
127