Lenovo 10A2, Руководство пользователя, Страница: 99 / 186

9. Slide the new secondary hard disk drive into the carrier until it snaps into position.
3
4
5
6
7
8
Figure 84. Installing the secondary hard disk drive
10. Connect the signal cable and the power cable to the primary hard disk drive and the new secondary
hard disk drive.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 109.
Installing the solid-state drive
Attention:
Do not open your computer or attempt any repair before reading and understanding the “Important safety information”
on page v.
This section provides instructions on how to install the 2.5-inch solid-state drive.
To install the solid-state drive, do the following:
Chapter 5
.
Installing or replacing hardware
87