Lenovo 10A2, Руководство пользователя, Страница: 63 / 186

9. Slide the new optical drive into the drive bay until it snaps into position.
Figure 25. Installing the optical drive
10. Connect the signal cable and the power cable to rear of the new optical drive.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 109.
Installing or replacing the card reader assembly
This section provides instructions on how to install or replace the card reader assembly.
Note: The card reader assembly is only available in some models.
Installing the card reader assembly
Attention:
Do not open your computer or attempt any repair before reading and understanding the “Important safety information”
on page v.
To install the card reader assembly, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See “Removing the computer cover” on page 42.
3. Remove the front bezel. See “Removing and reinstalling the front bezel” on page 42.
Chapter 5
.
Installing or replacing hardware
51