Lenovo 10A2, Руководство пользователя, Страница: 109 / 186

9. Insert the connector and cable of the new thermal sensor into the hole 1 in the chassis. Then, align the
two tabs on the plastic holder holding the thermal sensor with the two holes 1 and 2 in the chassis,
and push the plastic holder until it snaps into position.
Figure 98. Installing the thermal sensor
10. Connect the cable of the new thermal sensor to the thermal sensor connector on the system board. See
“Locating parts on the system board” on page 13.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 109.
Replacing the Wi-Fi units
Attention:
Do not open your computer or attempt any repair before reading and understanding the “Important safety information”
on page v.
This section provides instructions on how to replace the Wi-Fi units. The Wi-Fi units include a Wi-Fi adapter
card, a Wi-Fi card module and a rear Wi-Fi antenna cable.
Replacing the Wi-Fi units includes the following operations:
• “Removing the Wi-Fi adapter card” on page 98
• “Removing the Wi-Fi card module” on page 99
• “Installing the Wi-Fi units” on page 100
Chapter 5
.
Installing or replacing hardware
97