Lenovo 10A2, Руководство пользователя, Страница: 105 / 186

• To complete the installation or replacement, go to “Completing the parts replacement” on page 109.
Replacing the internal speaker
Attention:
Do not open your computer or attempt any repair before reading and understanding the “Important safety information”
on page v.
This section provides instructions on how to replace the internal speaker.
Note: The internal speaker is only available in some models.
To replace the internal speaker, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See “Removing the computer cover” on page 42.
3. Remove the front bezel. See “Removing and reinstalling the front bezel” on page 42.
4. Press the retaining clip 1 in the direction as shown and pivot the drive bay assembly upward at the
same time.
Figure 93. Pivoting the drive bay assembly upward
5. Disconnect the cable of the internal speaker from the internal speaker connector on the system board.
Chapter 5
.
Installing or replacing hardware
93