Lenovo 10152/F0AG, Руководство по техническому обслуживанию аппаратной части

Страница: 90 / 118

Figure 26. Installing a new battery
9. Reinstall the system board shield. See Removing and reinstalling the system board shield on page 76.
10. Reinstall the computer cover. See Completing the parts replacement on page 96.
11. Turn on the computer and all attached devices.
Note: When you turn on the computer for the rst time after replacing the battery, an error message
might be displayed. This is normal after replacing the battery.
12. Use the Setup Utility program to set the date, time, and any passwords. See Chapter 6 Using the Setup
Utility program on page 51.
Replacing the inverter
Attention
Do not open your computer or attempt any repair before reading and understanding the Important safety
information in the
Safety, Warranty, and Setup Guide
that came with your computer. To obtain a copy of the
Safety, Warranty, and Setup Guide
, go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the inverter.
To replace the inverter, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the cover is facing up.
3. Remove the computer cover. See Removing the computer cover on page 71.
4. Remove the VESA mount bracket. See Removing and reinstalling the VESA mount bracket on page 71.
5. Remove the optical drive. See Replacing the optical drive on page 74.
6. Locate the inverter in the computer. See Locating major FRUs and CRUs on page 63.
7. Remove the two screws that secure the inverter to the main bracket.
84
Lenovo S710 All-In-OneHardware Maintenance Manual