24
Louver Operations
NOTE:
Do not move louver by hand. This will cause the
louver to become out of sync. If this occurs, turn off
the unit and unplug it for a few seconds,
Setting Vertical Angle of Airflow
- While the unit is
on, use the SWING button on remote control to set the
direction (vertical angle) of airflow. Please refer to the
Remote Control User Guide for details.
NOTE:
When using COOL or DRY mode, do not set louver
at too vertical an angle for long periods of time. This
can cause water to condense on the louver blade,
which will drop on your floor or furnishings. When
using COOL or HEAT mode, setting the louver at
too vertical an angle can reduce the performance
of the unit due to restricted air flow.
Setting Horizontal Angle of Airflow
- The horizontal
angle of the airflow must be set manually. Grip the deflector
rod (See Fig.B) and manually adjust it to your preferred
direction.
Deflector
rod
Figure 32.
Deflector Rods
Manual Operation (without remote)
The manual button is intended for testing purposes and
emergency operation only. Please do not use this function
unless the remote control is lost and it is absolutely
necessary. To restore regular operation, use the remote
control to activate the unit. Unit must be turned off before
manual operation.
To operate your unit manually:
1.
Locate the MANUAL CONTROL button on the right-
hand side panel of the unit.
2.
Press the MANUAL CONTROL button one time to
activate FORCED AUTO mode.
3.
Press the MANUAL CONTROL button again to activate
FORCED COOLING mode.
4.
Press the MANUAL CONTROL button a third time to
turn the unit off.
Manual control
button
AUTO COOL
Figure 33. Manual Control
Air Filter Reminders (Optional)
Air Filter Cleaning Reminder - After 240 hours of use, the
display window on the indoor unit will flash “CL.” This is a
reminder to clean your filter. After 15 seconds, the unit will
revert to its previous display.
To reset the reminder, press the LED button on your
remote control 4 times, or press the MANUAL CONTROL
button 3 times. If you don’t reset the reminder, the “CL”
indicator will flash again when you restart the unit.
Air Filter Replacement Reminder
- After 2,880 hours of
use, the display window on the indoor unit will flash “nF.”
This is a reminder to replace your filter. After 15 seconds,
the unit will revert to its previous display.
To reset the reminder, press the LED button on your
remote control 4 times, or press the MANUAL CONTROL
button 3 times. If you don’t reset the reminder, the “nF”
indicator will flash again when you restart the unit.
