Lenel LNL-3300-M5, Руководство по установке

Страница: 52 / 184

LNL-3300-M5 Intelligent System Controller
52 —
revision 7
12 Status LEDs
• Power-up: All LEDs are OFF
• Initialization:
- LED's 1 through 6 are sequenced during initialization.
- LED's 1, 3, and 5 turn ON for approximately 1.5 seconds after the hardware initialization is
completed.
- The application code then initializes. The length of initialization time depends on the size of
database (about 3 seconds without a card database). Each 10,000 cards adds about 3 seconds to the
initialization.
- When LED's 1 through 4 flash at the same time, data is written to or read from flash memory.
Note: Do not cycle power while data is written to, or read from, the flash memory.
• Running: See the following table.
LED Description
1 Offline/online and battery status
Offline = 200 mS ON/800 mS OFF
Online = 800 mS ON/200 mS OFF
Double flash if battery is low
2 Host communication activity
3 Internal communication bus activity
4 TB2 communication activity (downstream enclosures)
5 Unassigned
6 Unassigned
YEL Onboard Ethernet speed:
OFF = 10 Mb/s
ON = 100 Mb/s (yellow LED)
GRN OFF = no link
ON = good link (green LED)
Flashing = Ethernet activity