StabPlus Quick Start v1
Page 1 of 4
Lemon Stabilizer Plus
- Quick Start Guide
This Quick Start guide outlines the basic setup of the Lemon Stabilizer Plus with a generation 2 or later Spektrum
transmitter. For other transmitters and additional details see:
Essential Instructions
https://www.rcgroups.com/forums/showatt.php?attachmentid=11910025&d=1554438806
and the
Reference Guide
https://www.rcgroups.com/forums/showatt.php?attachmentid=9835599&d=1488573620
Important:
As supplied, stabilization is turned OFF. To turn ON, see table below.
1)
Set up a new model on your transmitter. It must be set up as a conventional model with ailerons (single or
dual) and normal rudder and elevator. Even if your model has a V-Tail or has Elevons (e.g. is a Delta),
do not
do any V-Tail or Elevon mixing in the transmitter.
2)
Set the 3 white switches 4, 5 and 6 as shown in the table below. A pin is a good tool to flick the switches On
or Off. Make sure they are firmly at one side or the other.
Model configuration
Aircraft type
Switches
Wing
Tail
4
5
6
1x Aileron servo, conventional tail
Normal
Normal
ON
ON
Off
2x Aileron servos, conventional tail
Dual Ail
Normal
ON
ON
ON
1x Aileron servo, V-Tail. Tail servos connect to E and R
Normal
Normal
Off
ON
Off
2x Aileron servos, V-Tail. Tail servos connect to E and R
Dual Ail
Normal
Off
ON
ON
Elevons or Delta wing. Servos connect to A and E
Normal
Normal
ON
Off
Off
The photo above shows how the output pins support the various functions.
Channels 1 - 4 are the primary controls, in order: Throttle, Aileron, Elevator, Rudder.
Channel 5 (Gear) controls Stabilization mode and is
not
to be connected to a servo.
Go to Channel Assign, NEXT, and set
5 Gear:
to a suitable three-position switch, e.g. B or D.
Channel 6 (Aux1) may be used for Retracts or for the second servo in a dual Aileron setup.
Channel 7 (Aux2) can support Flaps and doubles as the Bind pins.
Channel 8 (internal to the StabPlus) is used for Master Gain (knob) on an 8-channel transmitter.
