Page 14/15
28October2022/Version 7
LEM reserves the right to carry out modifications on its transducers,
in order to improve them.
LEM International SA
Route du Nant-d’Avril, 152
1217 Meyrin
www.lem.com
ITZ 5000-S FLEX ULTRASTAB
Secondary current monitoring
The rack electronics incorporates a 0.1 Ω resistance in series with the measuring resistance for the monitoring of the secondary
current.
A BNC connector located on the rear panel provides a low-precision voltage output ±1 V full-scale which indicates a secondary
current flowing through the measuring resistance and the 0.1 Ω resistance.
The voltage on this connector is equal to (
I
P
(A) × 0.1 Ω × 5) /2500 (Volt).
As one example, if
I
P
is 5000 A, the voltage on this connector is 1 V. Similarly, if
I
P
is −5000 A, the voltage on this connector is −1 V.
As another example, if
I
P
is 2500 A, the voltage on this connector is 0.5 V. Similarly, if
I
P
is −2500 A, the voltage on this connector
is −0.5 V.
Delivery package
The LEM ITZ 5000-S FLEX ULTRASTAB package contains by default:
●
19-inch rack-mount ITZ FLEX ULTRASTAB electronics
●
Transducer head
●
European (Schuko CEE 7/7) and US/Japanese mains cables, 2 m each (with three-pole IEC C13 female connector).
●
Short-plug for 4 mm banana terminals and 15-pin D-Sub short-plug for analog output connector
(back panel of electronics rack)
Mandatory accessories
The 2 following accessories have to be separately ordered as per the table hereafter, otherwise the ITZ FLEX ULTRASTAB can
not operate without them:
●
Transducer head cable (interconnecting cable between transducer head and electronics rack)
●
Analog output cable
ITZ mandatory accessories
Available material Available length
Part number
Transducer HEAD cable
Non-Halogeneous
Non-Halogeneous
Non-Halogeneous
Halogeneous
Halogeneous
Halogeneous
Halogeneous
Halogeneous
10 m
20 m
30 m
10 m
15 m
20 m
25 m
30 m
71.16.13.001.0
71.16.17.001.0
71.16.20.001.0
71.16.13.000.0
71.16.15.000.0
71.16.17.000.0
71.16.19.000.0
71.16.20.000.0
Analog output cable
Non-Halogeneous
1.5 m
71.17.E7.001.0
* Other values might be possible upon request to LEM.
Optional
Calibration can be separately ordered as per the table hereafter:
● Calibration with certificate in ISO 17025 certificated laboratory
ITZ calibration (optional)
Available calibration
From −5000 A to +5000 A in differential method
5 or 11 points
or Special
