6
2.6 Connecting to your computer
• Connect the included USB cable to the USB connector jack on the back of the
charging base and the other end to an available USB jack on your computer
• Your computer may automatically recognize the device and install the correct
drivers . Wait a few seconds before using the headset
• If your computer doesn’t recognize the device, go to your computer’s Sound
Settings and select ‘DECT Headset’ as your default Playback/Recording device . You
may also need to select ‘disable’ on all other devices
2.7 Connecting to a Bluetooth enabled device
• Make sure Bluetooth is enabled on the device you’re trying to connect to . On most
devices like iPhone or Android, this can be found in your Settings menu
• Hold down the Bluetooth button on the top of the base for three seconds until the
LED light starts flashing
• Select ‘DECT Headset’ from the available devices list
• The LED light on your base will stop flashing once it’s successfully connected
2.8 Replacing the ear cushion
• Place your thumb underneath the ear cushion and pull up from the bottom
• To replace the earpad, match the notches at the top, then click the bottom into
place until you hear a click
