3
You can find more information about the VACUUM PLATE 300 at
Please always store these operating instructions with the device.
Congratulations on purchasing your VACUUM PLATE 300
You have chosen a first-class vacuum testing device.
It was developed and produced in accordance with the latest technology in the plastics-processing industry. It has
also been manufactured using high-quality materials.
VACUUM PLATE 300
testing device
Operating instructions
(Translation of the Original User Manual)
Dangerous voltage, danger to
life from electric shock:
There are
live components inside the device.
Maintenance and repairs are to be carried out by
trained specialist personnel only.
If the housing is damaged
, the power cord must be disconnected
from the
power source immediately. Keep the
device away
from moisture and wet conditions.
Before starting
, check the power cord, the plug
and the extension cable for electrical and mechan-
ical
damage.
Fire and explosion hazard
Admixtures (e.g. combustible or explosive gases or vapors), traces of oil, oil vapor and grease must not
be sucked in. Any
operation in a potentially explosive environment
is
prohibited.
The device must
only be operated with the filter plate installed
.
No hazardous leak tracer is to be used for testing the weld seams.
There is a
risk of inhalation
of
liquid particles. Read the material safety data sheet from the manufacturer of the material and
follow that company's instructions.
Risk of injury from plastic chips
at startup.
Damaged plastic glass
can lead to
implosion
. This may cause eye injuries. The plastic glass must
be protected against mechanical damage by impact or fall, for example. Do not put a defective VACU-
UM PLATE into operation.
Wear protective goggles.
Vacuum blower
causes
high noise levels. There is therefore a risk of hearing damage
while
operating the device.
Wear hearing protection.
Risk of inhalation of dust particles
while operating the device. If the membrane is contaminated,
dust particles can be sucked in and ejected by the blower. The
membrane
must be
free of impuri-
ties in the
test area.
If the device is being used on construction sites, a
fault current circuit breaker
must be used to
protect site personnel from electrical shock
due to dampness and moisture.
Warning
1. Important safety instructions
EN
