Leica Captivate, Техническое справочное руководство

Страница: 771 / 1060

Next step
Calculate
computes the alignment information.
Displayed is information about the calculated alignment information: Horizontal
offset from the line, height difference from the defined line and horizontal off-
set from the centreline.
Key Description
Store To store the results. Points are stored in the job together
with the alignment information. The points can be exported
with a report sheet later. The information is the same as if
the points had been measured along the alignment.
Page To change to another page on this panel.
Fn Settings To configure if the calculated points are stored with the origi-
nal point ID, a prefix or a suffix.
Next step
Page
changes to another page.
The fields and information displayed on the page are as defined in Road
Settings , Info page. Refer to "Road Settings,Info page".
3D viewer displays all the calculated points against the design data.
Description of fields
Field Option Description
Store point
ID with
Same point
ID
The same point ID from the selected job is
used when storing to the job.
If a point exists with the same point ID in the
job a warning appears. Choose to overwrite
the existing point or not.
Prefix Adds the setting for Store point ID with in
front of the original point IDs.
Suffix Adds the setting for Store point ID with at
the end of the original point IDs.
Prefix / suf-
fix
Editable field The identifier with up to four characters is
added in front of or at the end of the ID of
the calculated COGO points.
45.4.7 COGO Road - Create points
This menu function is available for staking/checking a line/local line.
This function allows creating points by defining a distance between points
along the working line and offsets to the working line.
Alignment Results,
Points page
Settings
Availability
Description
Roads - Road 771