15
_________________________________________________________________________________
5.7 Daily inspection before starting operation
- ground
- controls
- supports
- driving area
- horizontal levelling
- platform
- emergency stop button
- oil leakages
- emergency lowering
- working area
ATTENTION! If you note faults or missing equipment on this access platform, do not
put it into operation before the faults have been corrected. Never set the access
platform up in a place where the ground may be too soft. Beware of soft grounds and
potholes in particular
.
5.8 Use of emergency stop switches
-
To use an
emergency stop
or
killswitch
just press down the switch’s red cap (Picture 5
& 9).
-
Killswitches are used in emergency situations when normal shutting down procedures
are not possible. For example in accidents and other dangerous situations involving the
lift or its user.
-
Killswitches shut down the engine but outrigger monitoring stays switched on.
-
Killswitches in upper and lower control panels can be used at any time.
-
Killswitches can be returned to neutral position by twisting its red cap counterclockwise.
