43
Handling of fuel and refuelling
Figure 19 Combustion engine
Check the fuel level and refuel if
necessary (1). Before refuelling, check
whether the engine runs on petrol or
diesel.
Petrol specified by the manufacturer in
its manual must be used in a machine
with a petrol engine.
Hydraulic oil and hydraulic oil filter replacement
The hydraulic return oil filter (figure 20, (1)) is located on the side of the oil tank inside the
chassis. Replace the filter by removing the filter cap and replacing the filter cartridge. When
replacing the hydraulic oil, the oil can be removed with a suction pump from the opening of the
breather cap (2), or by opening the drain plug in the bottom of the chassis. In both cases, it is
important to clean the magnetic drain plug. The hydraulic pressure filter cartridge (3) must
always be changed when the return filter is changed. The pressure filter is located behind the
combustion engine, on top of the chassis.
Figure 20 Hydraulic oil filter
Содержание 135 NEO
