Leguan 135 NEO, Руководство оператора и по обслуживанию

Страница: 42 / 66

42
Grease nipples are located on both ends of the telescopic boom. One grease nipple is located
under the telescopic boom in the platform end of the boom (Figure 16). Two more nipples are
located under a protective cover in the front end of the upper boom (Figure 17).
Greasing of Telescoping Booms
Glide surfaces of the telescoping booms (bottom surface, picture 18) should be greased with
water resistant grease (e.g. Mobil XHP 222) during monthly greasing. The grease should be
applied on the bottom surface of both middle boom and extension, on a surface area of
approximately 30 mm wide measured from each side edge and for the whole visible length of
the booms when the telescope is fully extended (picture 18). Apply only a thin layer (< 1 mm) of
grease on the surface by using a brush for example.
Figure 18 Width of the greased surface on Middle Boom and Extension highlighted with red lines
Greasing of the Position Sensor Pins on the Outriggers
The position sensor pins on the outriggers should be cleaned and greased with water resistant
(e.g. Mobil XHP 222) during the yearly maintenance of the access platform. The pin is removed
from the outrigger by opening the locking screw on the end of the outrigger (p. 44, figure 23,
A). The pin is moved by a spring which is to be removed before the greasing. Apply only a thin
layer (< 1 mm) of grease on the surface of the pin by using a brush for example. After greasing
install the spring back on the pin and place the pin back on the outrigger and lock carefully it
with its screw.