41
Greasing of the slew ring
The slewing ring of the access platform must be greased monthly, according to the
maintenance schedule. It is important to notice that the
slewing ring has four (4) separate
greasing points
(Figure 15) which all must be greased individually. There are 3 grease nipples
on the backside of the slewing ring are connected to the gear and its bearings. One (1) grease
nipple on top of the slewing ring (a hole through the pedestal) is connected to the
ring’s ball
bearings. When applying grease to this grease nipple, it is important to apply it around the
bearing: after applying grease, turn the slewing ring approximately 20 degrees and apply grease
again. Repeat until the ring has gone around a full circle (360 degrees).
Figure 15: Slewing ring greasing
Greasing the telescopic boom chain pulley and inspection of the chain
A pair of leaf chains is used for telescopic boom movement. There are 3 pulleys which require
greasing. Pulleys are greased monthly.
Figure 17: Leaf chain pulley greasing points in the
front end of the upper boom.
Figure 16 Telescoping chain
pulley grease nipple
Содержание 135 NEO
