13
ADDING UNASSIGNED DEVICES TO A ROOM AND PAIRING THEM
If you did not assign all devices to a room during the discovery wizard, or if you have added additional devices and discovered them
after having assigned other devices, you can easily add them to a room and pair them.
1. Highlight the desired devices within the Unassigned Devices “room” and drag them into the desired room. This can be an existing
room or a room you just created in the tree.
2. Highlight the room you just dragged the devices into and click the
Wireless Device Pairing
button in the top section. A dialog
opens and LMCS checks the status of the devices. While checking the status, the
Status
column will display “Unknown” in yellow.
Once the check is complete, the status changes to green for paired devices, the controller status will display “Ready” and the
battery devices will show that they are paired.
Pair Wireless Devices
3. If any devices are not paired and the status displays as yellow or red, click
Re-pair
. The status of the controllers will turn yellow,
then red, as they are unpaired, and then pairing process starts. Once all devices are green, pairing is complete.
NOTE:
It is also possible to move previously paired devices from one room to another, by using the same process of dragging them to
the new room and then clicking
Wireless Device Pairing
.
DISCOVERING WIRED DEVICES CONNECTED TO AN LMBC-650
If you have one or more LMBC-650 bridges in your network, the wired devices connected to those bridges are not discovered during the
wireless discovery process. There are two possible methods for discovering the wired devices.
• Discover all wired devices connected to all LMBC-650s within a single area or within the entire building, in one process
• Discover the wired devices connected to a single LMBC-650
To discover all the wired devices, highlight the building or an area in the Devices tree, then click
Discover Hybrid Rooms
in the
information section. A
dialog opens and discover begins immediately.
