Document Number 411-0049-31 Rev A – November 2020
Installing the RoboFLIP 30 HDBT In-Ceiling HD PTZ Camera
This guide contains only the information required to install this product.
Refer to the Complete Manual for the RoboFLIP 30 HDBT In-Ceiling
HD PTZ Camera for additional product information.
Overview
This guide describes installation and related information for the
RoboFLIP 30 HDBT in-ceiling HD PTZ camera:
n
Camera with OneLINK HDMI camera
extension – 999-99800-100 (North
America), 999-99800-101 (Europe/UK),
999-99800-109 (Australia/New Zealand)
n
Camera with OneLINK Bridge A/V
interface – 999-99800-200 (North
America), 999-99800-201 (Europe/UK),
999-99800-209 (Australia/New Zealand)
Unpacking the Camera
Note
This camera is shipped with a tile brace for use in suspended acoustic tile ceilings. Safety wires for
suspending and leveling the tile brace are not included, but are strongly recommended. (we recommend the
Speed Connect Hardware Kit from Chief, part number CMSHDW)
Make sure you receive all the items you expected.
RoboFLIP 30 HDBT with OneLINK HDMI
999-99800-100 (North America), 999-99800-101
(Europe/UK), 999-99800-109 (Australia/New Zealand)
n
RoboFLIP 30 HDBT camera
n
Trim ring with mounting screws (shown mounted to
the camera)
n
Tile support brace
n
Cutting template
n
IR remote
n
OneLINK HDMI Receiver kit – includes:
o
OneLINK HDMI receiver
o
48 VDC power supply and AC cord set(s)
o
EZCamera RS-232 Control Adapter
n
Installation Guide
